If we were a famous battery manufacturer, the equally famous bunny would be drumming permanently at this point. polystar® Table welding machines of the 400 M series work just as persistently: they weld, weld, weld and weld…

There are three good reasons for perseverance:

1. Robust construction
   Double heating, automatic welding and cooling time, foot pressure switch and a sturdy housing complement each other. This combination allows many types of film up to 2 x 0.40 mm thick to be reliably welded.

2. Comfortable working
   The sealing process can be conveniently started using the foot switch. This leaves your hands free and you can operate the optional cutting device or prepare the next bag for sealing during the sealing and cooling time.

3. Foil welding using the proven heat impulse process
   Energy-saving (from 0.8 kWh) and therefore environmentally friendly, because electricity is only used when the welding pulse is triggered. The heat pulse process also means that there are no heating phases. Simply switch on the power, set the welding and cooling time and start welding.

The 410 M series goes one step further and impresses with sophisticated technology:

• The temperature can be adjusted to the exact degree

• The welding and cooling time can be selected in tenths of a second
  The welding processes always take place under the same conditions - no further adjustment is necessary.

• The welding parameters can be protected by an operator code

• An integrated piece counter, program memory for different settings and a stop and error function round off the intelligent control package.

But that’s not all: the highlight of this film welding series is the residual heat detection.

• The residual heat detection protects the heating elements, which means less wear and tear on the heating elements.

• Because the residual heat detection only transmits the difference between the actual temperature in the heating elements and the set target temperature to the control electronics, the required power consumption is considerably lower than with a conventional film sealing device using the heat pulse method.

The basic models polystar® 401 M and 601 M as well as 413 M and 613 M can be expanded to create perfect workstations with additional options: Cutting device, plug-in table, film dispenser for one roll of tubular film or film roll magazine for several tubular film rolls can be adapted to your work situation in the modular system.

These reliable polystar® Film sealing devices for use with both PE tubular film and prefabricated bags, e.g. made of polyethylene, PA/PE composites or thin aluminum composite films - in the warehouse, shipping, workshop, etc., etc., etc.